Ramps/Rumba Usb For Osx Install MOS Radiator

It is a feature rich all-in-one electronics solution for Reprap and other CNC devices.

There is also a MKS Base 1.2 board.

The RepRap wiki page has been depreciated, MKS Base.

There is a later, improved version 1.4.2, although it does cost significantly more.

It not only saves the complicated wiring process, but also saves the cost of external wiring, which is economical and practical.

Connect 5 (MS3) and 8 (high level) by using a 13 (short-circuit cap),The driver works in STEPDIR mode and it is 16 subdivisions.

Note:The interpolation of MS1, MS2, MS3 and 8, 9, 10 in STEPDIR mode is selected according to different subdivisions of different drivers.

When the SPI mode is selected, the motherboard must be programmed with the SPI working mode firmware(For a tutorial on changing the SPI firmware, please refer to the BIGTREETECH TMC2130 V1.1 Instruction Manual.);When selecting the STEPDIR mode, the firmware must be replaced with the firmware of the STEPDIR working mode, and the consistency of the subdivision must be observed.(Firmware is 16 subdivisions, Ramps1.6 plus must also choose 16 subdivisions) 2.

Ramps/Rumba Usb For Osx Install MOS Radiator

When using the heatbed with power over 140W,please be sure to install MOS radiator to prevent overheating and burning; When using the heatbed with power over 180W, please be sure to select heatbed MOS module for transfer to avoid the board burning due to long-time overheating; 3.

When you plug and unplug the drive into Ramps1.6 plus, please pay attention to the direction of the drive.

It should not be inserted in reverse to prevent the drive from burning, and the operation of the plug and unplug drive must be conducted under the premise of power failure.

Description of each driver SPI mode CS pin: (For details, please refer to the data RAMPS1.6 plus PIN) XCSD63 YCSD40 ZCSD42 E0CSD65 E1CSD66.

To find out more, including how to control cookies, see here.

Ramps/Rumba Usb Driver For Osx